First Singing Face with HLS!

[codec101]

Just sequenced my first singing face using HLS, gotta say it was very easy once I got going! This isn't the final product, I simply drew outlines of my channels on a scrap piece of OSB I had (from making tombstones last year), drilled some holes, stapled some lights and had some fun! Next step is to do the same but on some thinner BCX plywood, paint and seal! It will end up a little bigger too, 4x4, this piece was smaller and like 3/4 in thick.

I used 7 channels total, incans that I had laying around since I am using pixels this year. Controller is arduino mega programmed for 32 renard channels, using 2 dirkcheap SSRs.

Still working on some timing issues, first time messing with the face animation but HLS made it easy!

Would like comments or suggestions, THANKS!

 

[DrNeutron]

Nice! You are on your way.
I started with HLS last year just for the facial animations and used it for Halloween as well as Christmas.
Joe has done a fantastic job.
Hope to see your full Halloween show in the fall, make sure to post some vids.
:thup2:

 

[Christmasgeek]

Great job!! As Dr Neutron said Joe has made it fairly easy for us to do singing animations!