I-cybie As A Base For An Animatronic Rudolph?

A

Amdphenomx4

New member
Well, I know that there are rudolph dolls and based on this image, the I-Cybie uses 3 wire motors. Does this mean I could theoretically use a servodog or a similar controller to turn it into a cheap platform for animatronics? Unless that isn't the motor and its a rotation sensor. I'm on vacation though, so I can't check mine. Also, what do 3 wire Ni-Cd batterys have that 2 wire variants don't?
i-cybie7.JPG

Well, another forum gave information that the legs are servos. The head may not be.
 
Last edited:
Hi:
I don't know much about servos, etc, but the 3 wire batteries are two or more cells connected with the Plus and Minus in the center. A wire is connected here and that is the "common". The plus and minus of the batteries are connected so that you have a Plus and Minus supply. They are connected in series.

The Plus side of the battery and Common are the Plus side. The Minus and Common are the Minus supply.
 
You must log in or register to reply here.
Back
Top