Power Supply and fuse help

A

AJVenti

Member
I have a Mega tree that I want to run off 2 12v power supply's. Not sure how to connect them. I also want to fuse each out put. How do I connect the fuses and connect the 2 Power supply's

My mega tree has 6 inputs so I want to connect 3 inputs to one power supply and the other 3 to the other power supply. I am using a Renard 4 output controller
 
I have a Renard 4 output controller with 4 outputs and 16 universes
output one will have 2 universes
output two will have 2 universes
output three will have 1 universes
output four will have 1 universes
with 135 pixels on each

I was thinking I would run power supply #1 to the first three universes and power supply #2 to the last three
Running the V+ right to the pixels and not to the controller, and running the V- and data from the controller
 
Remember, you should always run Data and V- as well as V+ and V-. The best practice is to tie the V- lines together shortly before the 1st pixel. This is particularly important if the Controller and the V+ are coming from different Power Supplies
 
You must log in or register to reply here.
Back
Top