Problems opening a sequence saved from another computer

[Amigorick]

When I do a sequence on another computer with the same profile
As my show computer and then copy it and paste it into the sequence file
On the show computer, it opens but none of the channel programming is
There. All the channels are correct but none of the cells have any data. Why??
Using Vixen 2.1.

 

[rstehle]

Oh my, it's been so long since I used V2. I think that you can 'flatten profile in to sequence', then copy the sequence and load on to the other PC. Sequence should then play.

 

[jimboha]

Do you copy the attached profile into the Profiles folder?


Jimboha

 

[rstehle]

The profile is now part of the sequence.

 

[Amigorick]

Do you copy the attached profile into the Profiles folder?


Jimboha

Yes I made sure that the same profile was on both computers. I even attached it to the profile on the show computer
And it has all the correct channels but no data on any of them except when it is on the computer it was programmed on.

 

[Amigorick]

Oh my, it's been so long since I used V2. I think that you can 'flatten profile in to sequence', then copy the sequence and load on to the other PC. Sequence should then play.

I will try that!

 

[Amigorick]

I will try that!

Didn’t work.

 

[Amigorick]

Still having problems with pasting a sequence from another computer into the sequence file in Vixen 2.1.1.0 on my show computer.
I can attach it to the same profile on my Show Computer that is used on the other computer and there is no channel data!!!
This is driving me crazy !! Any suggestions !!!

 

[ZappinJackie]

I would just recreate the profile from scratch.

 

[Amigorick]

figured it out! Had to bring the profile into the sequence on the remote computer and then the sequence would open with the data included.

I would just recreate the profile from scratch.