Rbc9

[wilmar]

If you haven’t seen these ye the files are available now

https://www.thingiverse.com/thing:4692534

Sent from my iPhone using Tapatalk

 

[wilmar]

https://vimeo.com/493572027


Sent from my iPhone using Tapatalk

 

[Popo-B-Trippin]

Ordered .08mm nozzles and white PTEG yesterday... Can't wait to start printing these.

Thanks again for creating and sharing these!

 

[wilmar]

1mm nozzle .4 layer height looks good so far


Sent from my iPhone using Tapatalk

 

[sam-tip]

The RBC9 are really strong with the 1.0mm nozzle with .45mm layerheight.. Have to print a little slower but much stronger. About 50 minutes each. Had to increase my min layer time to 6 sec get the top point to print.

Sent from my SM-N981U using Tapatalk

 

[MichiganLights]

Had to increase my min layer time to 6 sec get the top point to print.

Hummh, good tip, (no pun intended) :biggrin2:

 

[MichiganLights]

1mm nozzle .4 layer height looks good so far

I've been struggling to get a good print at full size for my C9 250mm bulb with PETG. I'm currently running a 0.8 nozzle and have 1.0mm on hand.

Would it be too much to ask for your print settings, vase/std shell/thin wall #walls, adaptive layer, coast, iron etc.

https://forum.raise3d.com/viewtopic.php?p=69813#p69813