Vixen 2 Problem

[Amigorick]

I just connected everything up tonight and the first time I tried the channel tester everything worked great. I turned on every channel individually
and they all worked. Now after about an hour, I tried to turn on a few and it will not work for each individual channel. I can do select all and everything
comes on and will turn off when i select deselect all. I use Xbees all of my controllers. They work as they will turn on the lights. My settings are correct
on the ports for my two transmitters too. What am I missing !! Running the same computer I used last year with Windows 7.
Any suggestions would be greatly appreciated !!

 

[Amigorick]

No. I had a couple of items on one controller that were reversed and switched them. but after that it would still select each one individually.
I started connecting some static items in the yard and then went back and decided to run a sequence and even made sure it was attached to the
Profile I had used last year and earlier tonight when I created a 2020 Test Sequence. When I tried to run the sequence, some of the light would work
but not all. That is when I came in and closed the sequence and open the 2020 Test Sequence again. But this time, no individual control, just all on or all off.

 

[Amigorick]

Figured out last night that first, outside and up at the top inside my transmitter pole, one of the small jumper wires from the USB to TTL adapter and the Xbee Adapter had broken.
After just replacing the wire, it still would not work so I had to replace the TTL dongle too. It works fine now!! Thanks for you help!!