Setup for Ubiquiti NanoStation Loco M2

[TomL8345]

I have been using a Ubiquiti Nanostation Loco M2 for my wireless show network for the past couple of years. When I went to test my system I could not find my show network being broadcast. I followed a thread from the Green Site for a suggested setup on each screen, but that thread is no longer available.

I am using a RPi Master to run my show bridging from my Home Network (WLAN0) to my Show Network (ETH0) with the AP plugged into the ethernet port. Does anyone have a similar setup that can share screenshots of settings on the various pages for the Ubiquiti M2?

Thanks in advance,

 

[dirknerkle]

Here's the original thread I wrote on the setup topic - go to the first post of the thread

https://diychristmas.org/vb5/node/9023