kingjesse2
Member
Hey Everyone!
I hope I have a simple issue. When I plug in my LED strip for the Cosmic Color Ribbon (CCR) to my powered controller, about half the lights on the strip come on white. This is with no signal wires connected to the controller at all. Once I connect data to the controller, the previously unlit part of the ribbon actually follows the program, and the white side just stays lit white. Any idea what is causing this? I assume there is probably some kind of damage to the strip, and I can solder pretty well. Should I cut a part of the strip out? If so, which part? The first white LED?
Thanks!
I hope I have a simple issue. When I plug in my LED strip for the Cosmic Color Ribbon (CCR) to my powered controller, about half the lights on the strip come on white. This is with no signal wires connected to the controller at all. Once I connect data to the controller, the previously unlit part of the ribbon actually follows the program, and the white side just stays lit white. Any idea what is causing this? I assume there is probably some kind of damage to the strip, and I can solder pretty well. Should I cut a part of the strip out? If so, which part? The first white LED?
Thanks!