Tricks-C Controller Assembly Instructions

From doityourselfchristmas.com
Jump to navigation Jump to search

Disclaimer

ALL INFORMATION WITHIN THIS DOCUMENT IS PROVIDED "AS IS" AND WITHOUT ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. I DO NOT GUARANTEE ANY INFORMATION IN THIS DOCUMENT IS ACCURATE, AND IT SHOULD BE USED FOR ABSTRACT EDUCATIONAL PURPOSES ONLY.

The standard DIYC/ChristmasWiki Disclaimers also apply, as always.

Background


While there was a myriad of computer-based controller hardware available that ran under the Vixen software for controlling Christmas lighting, there were no LED display panels that could be controlled through Vixen. Robert Jordan decided that the Vixen community needed a LED sign and took it upon himself to design and prototype an LED scrolling board. While Robert had seen LED boards everywhere, he wanted one that allowed you to do text and animation. He envisaged a LED display board that could be your show sign and a place to show animations during the show.

THE LEDTRIKS was born. You can read more about it here.

While there was a great takeup on the design, there were always a few capabilities or limiations with the first LEDTRIKS, namely:

  • Connection via the parallel port
  • Heavy load on Vixen
  • Refresh rate problems, random LEDs being fired.


Schematic


Here is the Schematic. File:TRIXC V1.1a.pdf Image:TRIXC V1.1a.pdf

PCB Layout


Here is the Schematic.


BOM

Here is the Schematic.