ACL 5050 Strip Information and Building Help: Difference between revisions
Jump to navigation
Jump to search
(Created page with '==General Information== This is a wall washer that was created as just that but it has been used for much more than that. ==How to Build== ===Supplies Needed=== *Skillet - La…') |
No edit summary |
||
| Line 13: | Line 13: | ||
*1 RJ45 Jack | *1 RJ45 Jack | ||
Mouser [[http://www.mouser.com:80/ProjectManager/ProjectDetail.aspx?AccessID=f8a04f4a3a]] | Mouser BOM [[http://www.mouser.com:80/ProjectManager/ProjectDetail.aspx?AccessID=f8a04f4a3a]] | ||
[[File:Supplies.JPG]] | [[File:Supplies.JPG]] | ||
[[File:Skillet.JPG]] | [[File:Skillet.JPG]] | ||
===How to Build Strips=== | |||
[[File:Strip1.JPG]] | [[File:Strip1.JPG]] | ||
[[File:Strip2.JPG]] | [[File:Strip2.JPG]] | ||
Revision as of 20:03, 29 January 2012
General Information
This is a wall washer that was created as just that but it has been used for much more than that.
How to Build
Supplies Needed
- Skillet - Large enough to sit atleast 1 on it. Not necessary but makes it alot easier to solder.
- Solder Paste - A must as regular solder has to much flux and will cause issues
- 12 PLC6-5050 RGB leds
- Tweezers
- 8 150 ohm SMD Resistors (for blue and green)
- 4 360 ohm SMD Resistors (red Led)
- 1 RJ45 Jack
Mouser BOM [[1]]
How to Build Strips
