I have 4 Ray Wu 27 channel boards which all work ok. I saw a cheap 30 channel board on eBay, so I bought one.
It's one with indicator LED's on the outputs, it's marked QJ-30CHDMX-20140730.
I wired a few dumb RGB pixels to it and it works well on the test patterns, I then tried to run it with open DMX from Vixen 3 - nothing? The indicator light shows that it has DMX signal, the DIP address is ok, any suggestions?
The instruction "manual" mentions master and slave, is this of any relevance?
Any help appreciated!
Thanks
Sent from my iPad using Tapatalk HD
It's one with indicator LED's on the outputs, it's marked QJ-30CHDMX-20140730.
I wired a few dumb RGB pixels to it and it works well on the test patterns, I then tried to run it with open DMX from Vixen 3 - nothing? The indicator light shows that it has DMX signal, the DIP address is ok, any suggestions?
The instruction "manual" mentions master and slave, is this of any relevance?
Any help appreciated!
Thanks
Sent from my iPad using Tapatalk HD