MichiganLights
New member
I missed out on an end of year sale for some extra large lighted lawn ornament Christmas bulbs at HD. So I though I'll just 3D print them, how hard can it be?
For lighted props do you typically print in spiral/vase mode, convectional 1-wall, 2-wall, or fuzzy mode? Curious where you have your most success.
Ender 3 S1
PETG 1.75mm
0.8mm nozzle
240C
70C
60mm/sec.
For lighted props do you typically print in spiral/vase mode, convectional 1-wall, 2-wall, or fuzzy mode? Curious where you have your most success.
Ender 3 S1
PETG 1.75mm
0.8mm nozzle
240C
70C
60mm/sec.