Can't get led trix to run correct on wireless

[somtng4u2c]

It doesn't run fast enought to display correctly .
I'm using a pic-c instead of trix-c do you think that would make any differance.
I've used differant setting not much differance.

Any help or suggestions would be helpful.

 

[somtng4u2c]

bump

 

[LabRat]

I'm assuming you are using XBee's. There have been several threads about this in the past. As I recall the underlying issue was the serial settings. Whereas the standard recommended method for REN control is 8-1-Mark ... but the software driving the LEDTRICKS output (LTC.exe) is 8-N-1. So the solution is to reconfig the serial stream.

See the following discussion:
http://doityourselfchristmas.com/forums/showthread.php?22055-Controlling-LedTriks-with-Ren-W

 

[somtng4u2c]

settings i've tried
ch17
mac 802.15.04- no ack-with ack -maxstreaming with ack-maxstreaming with no ack
data 57600
parity none
packatization 0 threw 3
it seam's as thow it is scrolling to slow

 

[somtng4u2c]

bump

 

[somtng4u2c]

HELP!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
There has to be someone who has the ledtrix running on the xbee wireless that can give me some help/idea's

 

[Wayne J]

Have you check out these two threads?

http://doityourselfchristmas.com/forums/showthread.php?14308-Ren-W-amp-Triks-C

http://doityourselfchristmas.com/fo...olling-LedTriks-with-Ren-W&highlight=wireless

They should get you going.

 

[somtng4u2c]

checked thoes out no help.
Will send pic later to show whats going on

 

[LabRat]

Can't play at the moment. (Kids show is on this week, and I just started a new job (gainfully employed once more)).
My triks is still attached to the outside of the house. Might be able to pull it down next weekend (not the one coming up).

 

[somtng4u2c]

 

[somtng4u2c]

still hoping someone can help me out