Hello,
So I was looking at cutting out my own corroplastic decorations.
Questions:
1) 4mm or 10mm...locally I can only get 4mm including from home Depot.
2) cut plastic close to the size of the design? Or leave it a square.
2b) If you cut a square do you reenforce with a frame?
Bonus question for 2 points:
What gauge wire used to splice in when you have to reach to another hole on the panel? 5v pixel strings I'll be using, too bad the don't sell a bulk roll for the strands you buy.
Thanks in advance.
Tim
Thanks
So I was looking at cutting out my own corroplastic decorations.
Questions:
1) 4mm or 10mm...locally I can only get 4mm including from home Depot.
2) cut plastic close to the size of the design? Or leave it a square.
2b) If you cut a square do you reenforce with a frame?
Bonus question for 2 points:
What gauge wire used to splice in when you have to reach to another hole on the panel? 5v pixel strings I'll be using, too bad the don't sell a bulk roll for the strands you buy.
Thanks in advance.
Tim
Thanks