I’m not sure I’m doing this right or maybe this drill press isn’t good enough. The issue I’m running into is that when I have the step bit installed in the chuck I can’t drill all the way through a 1/2” piece of pvc and still have enough clearance to lift the pvc up and flip it over. I can get the bit do go through one side if I push the pipe all the way up to touch the bit then lower the bit. But when I raise it back up the pvc is touching the bit. There isn’t room to flip the pipe unless I lower the work table and ride it back up. The spindle travel on this is 2”. Seems like I don’t have the drill press setup right or something. The box says 8”. Any advice??