Help a newbie

[sdeyoreo]

How do you hook up an SSR to the parallel port?:
1) SSR + in to one of the data pins and SSR -in to a ground like pin 25?
- OR-
2) Is the parallel port open collector so SSR +in goes to 5 v thru a resistor and SSR -in to parallel port data pin?

And, in vixen, for a plugin, do I use a "Basic Parallel"?

Thanks.

 

[robots4joey]

I believe there is a way to do this, but most of us use a controller board in-between the parallel port and the SSR.

this is necessary if you want more than (I think) 8 channels. but there is a way to do a few channels directly fron the parallel port.

I'll go do some searching... (I'll be back)

 

[Mudsculpter]

This is probably what you are looking for (or some facsimile thereof)

http://computerchristmas.com/christmas/link-how_to/HowToId-2/LowLimit-0

 

[robots4joey]

K, here is the first one I've found:

http://computerchristmas.com/christmas/link-how_to/HowToId-2/LowLimit-0

The second page has pin-outs


There are a few more direct parallel port how to's on the Computer Christmas site. That site is a great place to get started.

If you were wanting more than 8 channels check out the christmas wiki at the top right of this page for controller options.

 

[robots4joey]

Hey! you beat me

 

[sdeyoreo]

Thanks, I've been to all those sites. The one you guys posted connects the SSR +in to the PC, so that's the way I'll go.
I've got 3 SSRs wired to a 25 pin connector, I'll try it when I get home, let you know.