I picked up 4 flat white tree wireframes up from someone giving them away after New Years. They are 3, 4, 5 and 6ft. They are 100% working with incan AC lights but I want to rip those off and add pixels. I attached just one photo (they are all the same - just different sizes). Any thoughts on an approach to add pixels?
A few options I'd likely consider -
1. Vertical Boscoyo pixel trips giving it a traditional pixel tree look.
2. Zip tie along the outside outline and then interior zig zag of the wireframe starting in the bottom left corner (that would leave the end of the strand near the top so I can connect to a coro start topper)
3. Cover it in chromamesh (not too confident this will work out too well) and make it pretty dense with pixels
Any other suggestions?
Tim
A few options I'd likely consider -
1. Vertical Boscoyo pixel trips giving it a traditional pixel tree look.
2. Zip tie along the outside outline and then interior zig zag of the wireframe starting in the bottom left corner (that would leave the end of the strand near the top so I can connect to a coro start topper)
3. Cover it in chromamesh (not too confident this will work out too well) and make it pretty dense with pixels
Any other suggestions?
Tim