I've finally got my second Ledtriks up and running after all these years. I've never run a pair of 'triks panels together before and need some guidance.
Setup:
2x 3 panel Ledtriks display running from the Ledtriks driver board off a Triks-C
Display 1 --- Display 2
Display 1 Triks-C jumper J6 set to main (no jumpers)
Display 1 Triks driver board Board Address SEL set to 1
Display 2 Triks-C jumper J6 set to 2 (jumper on 4th set of pins)
Display 2 Triks driver board Board Address SEL set to 1
Triks.dat file is as follows
COM8:
2
50
50
100
0
Now, my issue is that BOTH Display 1 and Display 2 run in "stereoscopic" mode, both sets of display panels show the same images.
Scrolling text or images, both will start and end within the confines of their own panels and wont pass along in a continuous left to right sweep
It appears both Trik-C's are running independent of each other despite the fact they are chained.
Any Clues?
Setup:
2x 3 panel Ledtriks display running from the Ledtriks driver board off a Triks-C
Display 1 --- Display 2
Display 1 Triks-C jumper J6 set to main (no jumpers)
Display 1 Triks driver board Board Address SEL set to 1
Display 2 Triks-C jumper J6 set to 2 (jumper on 4th set of pins)
Display 2 Triks driver board Board Address SEL set to 1
Triks.dat file is as follows
COM8:
2
50
50
100
0
Now, my issue is that BOTH Display 1 and Display 2 run in "stereoscopic" mode, both sets of display panels show the same images.
Scrolling text or images, both will start and end within the confines of their own panels and wont pass along in a continuous left to right sweep
It appears both Trik-C's are running independent of each other despite the fact they are chained.
Any Clues?