Hello,
Long story short, something is seriously wrong with my SS24. The diagnostic firmware runs flawlessly, the voltage tests correctly, and it does indicate data is received when a sequence is run. However, once the operational firmware is in place, no channels work (the power LED is lit and all fuses are good, it just looks like data is not flowing even though diagnostics show it does).
I have spent more hours than I should have troubleshooting and am totally stumped. At this point I am looking to basically turn it into an expensive power strip. My experience and knowledge is not such that I can program the firmware.
Is there anyone out there that could alter diagnostic firmware to just turn on all channels and leave them on?
Any help would be greatly appreciated.
Thanks.
Long story short, something is seriously wrong with my SS24. The diagnostic firmware runs flawlessly, the voltage tests correctly, and it does indicate data is received when a sequence is run. However, once the operational firmware is in place, no channels work (the power LED is lit and all fuses are good, it just looks like data is not flowing even though diagnostics show it does).
I have spent more hours than I should have troubleshooting and am totally stumped. At this point I am looking to basically turn it into an expensive power strip. My experience and knowledge is not such that I can program the firmware.
Is there anyone out there that could alter diagnostic firmware to just turn on all channels and leave them on?
Any help would be greatly appreciated.
Thanks.