Deuce Wills
New member
Arduino Mega 2560
2 - SainSmart SSR boards
Vixen 3
I’m new to Xmas light sequencing. This is my first time. I have a couple of songs sequenced in vixen. Everything is great except when I have all 16 relays(lights) on at the same. No Go. None of them come on. Any part of my vixen sequence that turns on more than 10 relays results in no relays turning on. However, the setup display of my house in vixen shows all lights on. It doesn’t matter which song either.
I assumed it was a current problem so I added another 5 volt power supply so each SainSmart board has it’s on separate 5 volt supply...no go.
Today, I swapped in a spare computer power supply to provide 5 volts to the relay boards....still no go.
Anyone have any ideas?
Thanks
Deuce
2 - SainSmart SSR boards
Vixen 3
I’m new to Xmas light sequencing. This is my first time. I have a couple of songs sequenced in vixen. Everything is great except when I have all 16 relays(lights) on at the same. No Go. None of them come on. Any part of my vixen sequence that turns on more than 10 relays results in no relays turning on. However, the setup display of my house in vixen shows all lights on. It doesn’t matter which song either.
I assumed it was a current problem so I added another 5 volt power supply so each SainSmart board has it’s on separate 5 volt supply...no go.
Today, I swapped in a spare computer power supply to provide 5 volts to the relay boards....still no go.
Anyone have any ideas?
Thanks
Deuce