Mike_Parks
New member
Hi,
Having a problem getting Vixen 2 to work with two Arduinos (MEGA 2560). I have the same simple 5 channel sketch loaded onto both Arduinos. One is on com3 the other on com4. I can get them each to work separately with a 5 channel Vixen 2 sequence. I have built a profile with 10 channels. Channels 1 to 5 on one generic serial port on com3 and channels 6 to 10 on another generic serial port on com4. However, when I run the sequence the lights do not behave properly at all.
Any ideas would be much appreciated.
I have managed to get Vixen 3 to work with two Arduinos but it is far too complicated for my needs and I would much rather stick with Vixen 2 which I have come to grips with.
Thanks,
Mike
Having a problem getting Vixen 2 to work with two Arduinos (MEGA 2560). I have the same simple 5 channel sketch loaded onto both Arduinos. One is on com3 the other on com4. I can get them each to work separately with a 5 channel Vixen 2 sequence. I have built a profile with 10 channels. Channels 1 to 5 on one generic serial port on com3 and channels 6 to 10 on another generic serial port on com4. However, when I run the sequence the lights do not behave properly at all.
Any ideas would be much appreciated.
I have managed to get Vixen 3 to work with two Arduinos but it is far too complicated for my needs and I would much rather stick with Vixen 2 which I have come to grips with.
Thanks,
Mike