ACL 5050 Strip Information and Building Help: Difference between revisions
Jump to navigation
Jump to search
Created page with '==General Information== This is a wall washer that was created as just that but it has been used for much more than that. ==How to Build== ===Supplies Needed=== *Skillet - La…' |
(No difference)
|
Revision as of 18:10, 29 January 2012
General Information
This is a wall washer that was created as just that but it has been used for much more than that.
How to Build
Supplies Needed
- Skillet - Large enough to sit atleast 1 on it. Not necessary but makes it alot easier to solder.
- Solder Paste - A must as regular solder has to much flux and will cause issues
- 12 PLC6-5050 RGB leds
- Tweezers
- 8 150 ohm SMD Resistors (for blue and green)
- 4 360 ohm SMD Resistors (red Led)
- 1 RJ45 Jack
Mouser [[1]]
