TomsLEDs
Supporting Member
This would have been good to post earlier in the thread. Has the card ever worked to control pixels? Does any configuration information get saved when you change and save it?
Actually the card works fine. The problem I have is I have some GE pixels that need timing adjusting and that's only available in firmware 5. I did build a completely different network using a Cisco router that uses the same network addressing that is native to the card. I ran it on my i7 laptop with no internet and the E682 as the only ethernet device. The same reaction occurred only this time I could see a rapid flashing amber LED on the router from the computer indicating it was transmitting data. However, there was nothing matching on the card's ethernet port. I did a little research on the prop programmer. There was a prop controlled video card that the programmer device was connected by using the 4 pin program header port. This port looks identical to the one on the E682. Well as I was typing this, Jim confirmed that you do use the program port and emailed me the procedure. Now I just need to buy a programer somewheres?